+86 532 8818 7669 Mon - Fri 09:00 - 17:30 R1303, No. 2 Building, No.243 Ningxia Road, Qingdao, China
ISO 9001:2008
The Best Choice
#3 in China
OEM Service
Laser Marking
Get A Quote

RUNLIN™ 10kV Cold Shrink Cable Indoor / Outdoor Terminations

RUNLIN™ 10kV Cold Shrink Cable Indoor / Outdoor Terminations

RUNLIN™ 10kV Cold Shrink Cable Indoor / Outdoor Terminations suitable for voltage 3.6/6kv, 6/6KV, 6/10kv, 8.7/10kv, 8.7/15kv .

It mainly divided into the single core, two-core, three-core, four-core, five-cove, which is widely used in the terminals processing and middle connection of low-voltage electric cable. Cold Shrinkable cable accessories adopt the most advanced technology of cold shrinkable, dispense with using fire or others special tools. Only need to draw out the wires, when you prepare for installation, and the elastomer will rapidly shrink and appress to the installation position.

It suit for crosslinking rubber power cable connection, sealing, insulation, electric stress relief, especially suitable for oil refinery, chemical, mining and other flammable and explosive place.

Our tubes use silicone rubber NOT EPDM.


Used widely, high prominent anti-fouling, anti-aging, hydrophobicity and heat-resisting, cold-resisting performance.
Especially suitable for areas of high altitudes, cold, wet, umidity, salt spray and heavy pollution.
Popular for oil field, chemical industry, diggings, tunnel and others various inflammable and explosive locations.
Manufacturing equipment advanced, automaticity high dependable performance.


Offer real advantages over other cable sealing methods:
• Reliable seal against water.
• Tough, resilient rubber holds pressure seal, even after exposure.
• Broad application range; can lower inventory costs.
• Eliminates need for heat source or special tools.
• Reduces installation time for sealing jobs.
• Easily removed for inspections or disconnects.
• Resistant to fungus, ozone, alkalies and acids.
• Constant radial pressure helps connectors stay together in wind and vibration.

Runlin cold shrink tubing using in State Grid Corporation of China

Single-core cold shrink indoor termination


Single-core cold shrink outdoor termination


Three-core cold shrink indoor termination


Three-core cold shrink outdoor termination


Cold shrink termination Semi-conductive Tape PVC Tap Cable holder
Cold shrink tubing Filling adhesive Measuring tape Ribbon gauze
Weave ground wire Constant force Gloves Paper card
Insulation tube Sealing gum Clean paper Installation technology
Sealed tube Thermal grease Woundplast Certificate

Technical Data

Item Data
Alternating 5min power frequency withstand voltage 39kv
1min power frequency 35kv
15min power frequency withstand voltage 23kv
Partial discharge below 15kv<2pc
Dynamic stability  (short circuit 1 time ) No deformation and welding
Under High temperature 95-100℃impulse voltage The positive and negative polarity 10 times under 95 kv
  • Geometrical stress cone structure products, specific creepage distance>31mm/kv;
  • Made of silicone rubber, suitable for Grade III&IV contaminative areas;
  • Simple and fast installation, no need naked flame, safe and reliable;
  • Has lasting radial pressure to the cable itself, keep the same “breathing” with the cable;
  • Good seal water proofing, to ensure long-term reliable running.

Product standard: GB/T12706.4-2002 & IEC60502-4


Voltage Model Applicable Section(mm²)
10kV Cold Shrink Single-core Indoor/Outdoor Cable Termination RL-CT10KV/I/O-1-1 25-50
RL-CT10KV/I/O-1-2 70-120
RL-CT10KV/I/O-1-3 150-240
RL-CT10KV/I/O-1-4 300-400
Voltage Model Applicable Section(mm²)
10kv Cold Shrink Three-core Indoor/Outdoor Cable Termination RL-CT10KV/I/O-3-1 25-50
RL-CT10KV/I/O-3-2 70-120
RL-CT10KV/I/O-3-3 150-240
RL-CT10KV/I/O-3-4 300-400

If you need special terminations, please fill out the below form with your requirement, we will reply asap..

Additional Information

To request additional product information please fill in the form below.